Custom Arduino Bootloader Flashed
Posted on June 19, 2012 in Category: Blog - 0 Comments

It took some work. I found a few problems with the initial board design so I fixed those up (with wire hackery on the breadboard) and was able to flash the bootloader to the ATMega chip. After I flashed the custom bootloader, I was able to upload a test sketch which blinked an LED on/off. I used the "USR" pin available on the Comet board, tying it to a resistor through to an LED on the breadboard. I can tell having this breadboard is going to be a lot of fun!
Post a comment.
Notable Posts.

July 24, 2012

June 18, 2012

June 12, 2012

May 21, 2012

May 14, 2012

Sept. 30, 2011

Sept. 29, 2011

Sept. 2, 2011