Wi-fi Module Test: PASS
Posted on July 2, 2012 in Category: Blog - 0 Comments
![Wi-fi Module Testing Wi-fi Module Testing](/images/Blog/Comet64WifiModule.jpg)
I ran into some trouble when testing this... I guess there is always something that can go wrong. After a lot of time spent tracking this down with Agent Friday, we noticed that a module used for TX/RX to my PC (converts logic levels into RS-232 levels) requires 5 volts and not 3.3 volts, which is what I was supplying it. After we got that figured out, we discovered one of the AVR pins wasn't soldered down. It figures it had to be one of the pins that I needed for testing this. Once I got it soldered down, I realized that the test program had the TX and RX lines mixed up. Three problems solved at once.
Post a comment.
Notable Posts.
![Comet+ Prototypes Ready to Show at CommVEx Comet+ Prototypes Ready to Show at CommVEx](/images/nifty/CometPlus-CommVEx.jpg)
![Comet+ Prototype Boards Have Arrived Comet+ Prototype Boards Have Arrived](/images/blog/CometPlusProto-92.jpg)
![Name of Comet 2.0 Will Be Comet+ Name of Comet 2.0 Will Be Comet+](/images/CometSquare-Gray.jpg)
![Comet 2.0 Block Diagram Comet 2.0 Block Diagram](/images/nifty/Comet2Block.jpg)
![Custom Arduino Bootloader Test: PASS Custom Arduino Bootloader Test: PASS](/images/nifty/CometBootloader.jpg)
![Comet 2.0 Comet 2.0](/images/CometSquare-Gray.jpg)
![Wi-fi Prototype Shown at ECCC 2011 Wi-fi Prototype Shown at ECCC 2011](/images/CometSquare-Gray.jpg)
![Comet64 Upgrade Prototype Comet64 Upgrade Prototype](/images/nifty/Comet64UpgradePrototype.jpg)